WELCOME TO Hongkong NKF Machinery Co.,Limited. English | Spanish

Don't need the whole Bearing Kit just one bearing with fasteners? Then this is what you need. About the bearings: These bearings are made by the same American manufacturer that has been making bearings for glider rockers since the rockers were invented. They are a low speed bearing made of steel construction throughout. They have a light zinc finish and are lightly greased internally when assembled. The metal shield prevents dusts and contaminants from easily entering the bearing. The bore is smooth and fits a standard 3/8" bolt perfectly. This allows you to use any length bolt you need to build or repair your rocker. We have personally repaired several rockers with this bearing with great success and happy customers.

Please note we do not have brand specific data... we only know that this bearing fits many chairs. Please scroll down to the bottom of this page for specific measurements.Please review the measurements below to make sure this kit is what you need because we will not accept returns... due to the large amount of customers who are not measuring to make sure these ina bearings fit their chair. 

Please note we do not have brand specific data (even if you call us - we still don't know)... we only know that this bearing fits many chairs. Please scroll down to the bottom of this page for specific measurements. This hardware kit is what you need to build one rocker. You will need to drill a 1-1/8" hole for the bearings to push into. We highly recommend using nothing but hardwoods. The bolts, nuts and washers are 3/8". The screws are #6 square recess drive. This produces the same simple arrangement as used by the chair manufacturers. 

About the bearings: These fag bearings are made by the same American manufacturer that has been making bearings for glider rockers since the rockers were invented. They are a low speed bearing made of steel construction throughout. They have a light zinc finish and are lightly greased internally when assembled. The metal shield prevents dusts and contaminants from easily entering the bearing. The bore is smooth and fits a standard 3/8" bolt perfectly. This allows you to use any length bolt you need to build or repair your rocker. We have personally repaired several rockers with this bearing with great success and happy customers.

Please review the measurements below to make sure this kit is what you need because we will not accept returns... due to the large amount of customers who are not measuring to make sure these glider rocker bearings fit their chair. Also please note we do not have brand specific data (even if you call us - we still don't know)... we only know that this bearing fits many chairs. Please scroll down to the bottom of this page for specific measurements. 

898

22220 ES K C3

492 A